5.000 W ultra-light, high-power amplifier

Share this article on :
This circuit is of an 2x 2,500W RMS stereo amplifier, super-light and without switching-mode power supply. The circuit just shows a channel, and the power supply that it assists to the two channels. The audio circuit should be duplicated, but the power supply assists to the two channels without problems.
A special care should be destined to the insulating transformer of the audio line, that should be of audio-high-quality, of the type used in microphone pre amps input line. The whole group (2 channels) of 5,000W RMS it should not weigh more than 32 lbs, already inside of an appropriate metallic box.

This circuit is exclusively for amateur use. It contains not-isolated parts of the electric AC net and it can be very dangerous. The connections for the speakers are not isolated of the domestic AC net and it requests extra care. This procedure seeks to substitute a conventional power supply with great weight and cost reduction, without necessarily to use a switching-mode power supply.
This procedure cannot be allowed in some countries for commercial-use. The author doesn't have any responsibility for the form as that circuit it will be applied.


5 komentar — Skip to Comment

Tafser Ahmed mengatakan...

good post
hd video song

assignment writer mengatakan...

This is an informative post. Thanks for the share, was really useful. I am sure others will find it helpful also.

Pranatosh Das mengatakan...

Can u send me pcb design for this schematic?

Pranatosh Das mengatakan...
Komentar ini telah dihapus oleh pengarang.
Residential Painting mengatakan...

This amplifier looks of a high voice quality. I think it will be expensive too. But thanks for sharing the details and schemetic for this amplifier. Because as you said not anybody can use it.

Posting Komentar — or Back to Content